
Document feeder base assembly
Before proceeding, remove the following components:
●
Document feeder input tray. See
Document feeder input tray on page 69.
●
Document feeder cover. See
Document feeder cover on page 70.
Remove the document feeder base assembly
1. Disconnect one FFC (callout 1), and then release the adhesive FFC protector on the document
feeder base (callout 2).
TIP: Use two-sided tape to replace the FFC protector during reassembly.
Figure 1-102 Remove the document feeder base assembly (1 of 3)
2
1
ENWW
Removal and replacement procedures
75
Comentarios a estos manuales