
6. Place the product rear-side up, and then remove four screws (callout 1).
Figure 1-86 Remove the low-voltage power supply assembly (6 of 9)
1
7. Remove three screws (callout 1), disconnect one connector (callout 2) and separate the low-
voltage power supply assembly (callout 3) from the product.
CAUTION: Do not attempt to completely remove the low-voltage power supply. The power
supply is still connected to the product by three internal connectors.
Figure 1-87 Remove the low voltage power supply assembly (7 of 9)
1
2
3
66 Chapter 1 Removal and replacement ENWW
Comentarios a estos manuales