VDO Radio Module RM 8204 Manual de servicio descargar pdf (Pagina 32)

Pickup roller

Before proceeding, remove the following components:

●

Separation pad assembly. See

Separation pad assembly on page 13.

●

Right cover assembly. See

Right cover on page 16.

●

Left cover assembly. See

Left cover on page 17.

Rotate the pickup roller to the service position

To gain access to the roller locking tabs you must rotate the roller to the correct position for removal.

1. When the product is in the Ready state, press and hold the Auto-On/Auto-Off (power) button for

about seven seconds or until the Ready light turns off.

TIP: Optionally, unplug the power cord, and then plug the cord back in.

2. Make sure that one sheet of paper is loaded in the input tray.

NOTE: If more than one sheet of paper is loaded in the tray, this procedure will not be

successful.

3. Press and release the Auto-On/Auto-Off (power) button and within two seconds press and hold

down the cyan cartridge button. Hold the cyan button down for about five seconds, or until the

initialization process begins.

NOTE: Immediately after the Auto-On/Auto-Off (power) button is pressed, all of the control

panel lights illuminate briefly (for about two seconds). You must press the cyan cartridge button

while the lights are illuminated.

4. When the product finishes initializing, the roller rotates into the removal position. Turn the product

off. Unplug the product before removing any components.

NOTE: When the roller is in the removal position, the sheet of paper will have been pulled into

the paper path by about 12 mm (.5 in). This is visual confirmation that the roller has rotated to the

removal position.

14 Chapter 1 Removal and replacement ENWW

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 169 170

Sin comentarios

VDO Radio Module RM 8204 Manual de servicio Pagina 32