VDO CR 2201 Especificaciones descargar pdf (Pagina 31)

1 OPERATION

5. ADDRESS TYPE is selected; use the [SFT/ +/-] key to choose address

type: ADDRESS-CAST for a specific ship, or BROAD-CAST for all ships.

For BROAD-CAST go to step 7.

6. For ADDRESS-CAST, press the [NEXT] key to choose “MMSI,” and then

enter the MMSI of the receiving ship.

7. Press the [NEXT] key to choose MSG TYPE.

8. Use the [SFT/ +/-] key to choose message type: NORMAL (message other

than safety) or SAFETY (important navigational or meteorological warning).

Note: Some non-FURUNO AIS transponders may not be able to receive a

“normal” priority message. Confirm feasibility with receiving vessel.

9. Press the [NEXT] key to choose CHANNEL#.

10. Use the [SFT/ +/-] key to choose which channel to transmit your message

over; CH-A, CH-B, BOTH (CH-A and CH-B), or “A OR B” (either channel).

11. Press the [ENT] key to register settings and return to the CREATE MSG

sub-menu.

12. Press the [2] key to choose SET MSG.

Number of

characters used

[SET MSG]

123 0/(151-161)*

Data Input Mode

123: Numeric

ABC:Alphabet

Use the [SFT/ +/-] key

to switch modes.

*: Up to 161 characters can be entered, but recipients receive

the following number of characters.

NORMAL message with BROAD-CAST : 156 characters

NORMAL message with ADDRESS-CAST : 151 characters

SAFETY message with BROAD-CAST : 161 characters

SAFETY message with ADDRESS-CAST : 156 characters

SET MSG screen

13. Key in your message, using alphanumeric characters. Use the [SFT/ +/-]

key to switch between numeric and alphabet input. If you enter a wrong

character, use the [CLR/ALM] key to erase it.

14. Press the [ENT] key to save the message and return to the CREATE MSG

sub-menu.

15. Press the [3] key (SEND MSG) to send your message.

The screen displays “NOW SENDING” during transmission and “SEND

COMPLETED!” when transmission has been completed. (MMSI no. is shown

along with “SEND COMPLETED” if the message was transmitted to a specific

ship.) If the message could not be sent, “SEND FAILED” appears. And if you

did not receive acknowledgement of a message, despite successful

transmission, “UNSUCCESSFUL” appears.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 79 80

Comentarios a estos manuales

Sin comentarios

VDO CR 2201 Especificaciones Pagina 31

Comentarios a estos manuales