VDO CR 2201 Especificaciones descargar pdf (Pagina 23)

1 OPERATION

1.7 Plotter Display

The plotter display automatically appears at each power on. You may also

display it as below. AIS targets are displayed automatically.

A target (target marker is hollow) indicates the presence of a vessel equipped

with AIS in a certain location and course. If you desire to know more about a

vessel’s data, select as in step 4 below.

1. Press the [MENU] key to open the menu.

2. Press the [2] key to show the PLOTTER display.

3. Use the [1] or [3] key to choose the range: [1] key to lower it; [3] key to raise

it. The available ranges are (in nm) 0.125, 0.25, 0.5, 0.75, 1.5, 3, 6, 12, and

24.

4. To find a target’s data, do the following:

a) Use the [◄] or [►] key to fill a wanted target marker in black; namely,

activate the target.

b) Press the [SFT/ +/-] key to display SOG/COG and CPA/TCPA alternately.

c) Press the [ENT] key to display other data. Use the [▼] or [▲] key to scroll

the data. The data is the same as that shown on the TARGET DATA

sub-menu. For details, see paragraph 1.8.

[FURUNO]

SOG:

10.2 kt

COG:

135.0 deg

INTRD: 0

[ ]: FWD

[ ]: BACK

Selected target

(circle filled in black)

Target

(hollow circle)

Own ship marker

Speed over ground*

Course over ground*

Number of targets

within the guard zone

(CPA setting)

Display range

Use keys shown to select

target to display its data.

RNG: 1.50

Target name

* = Use [SFT +/-] key to

show CPA/TCPA.

Plotter display

Note 1: If no signal is received from an AIS target for three minutes and twenty

seconds it is declared a lost target. Six minutes and forty seconds later

it is erased from the screen.

Note 2: When a target’s CPA and TCPA are lower than set in paragraph 1.6,

the target flashes and the audio alarm sounds (if active). Press the

[CLR/ALM] key to stop the flashing and silence the audio alarm. Take

suitable measures to avoid collision.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 79 80

Comentarios a estos manuales

Sin comentarios

VDO CR 2201 Especificaciones Pagina 23

Comentarios a estos manuales